![]() Feed and speed overrides are set to on (like M48).Feed rate mode is set to units per minute mode (like G94).Distance mode is set to absolute (like G90). ![]() Axis offsets are set to zero (like G92.2) and origin offsets are set to the default (like G54).These commands can have the following effects: M02 leaves the next line to be executed as the M02 line. ![]() If a program is stopped by an M00, M01, selecting Cycle Start restarts the program at the following line of the G-code program. It’s okay to program M00 and M01 in MDI mode, but the effect probably won’t be noticeable because normal behavior in MDI mode is to stop after each line of input. To stop a running program temporarily, but only if the optional stop switch is on, program: M01 To stop a running program temporarily, regardless of the optional stop switch setting, program: M00 PROGRAM STOP AND PROGRAM END (M00, M01, M02, AND M30)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |